Remote Pro RPC419 Garage Door Remote Specifications
| Remote Dimensions | 5.5 x 3 x 1.4(cm) |
| Remote Weight | 24g |
| Manufacturer | Wholesale Garage |
| Made To Suit | SEIP |
| Model Number | WGC419, RPC419 |
| Batteries Included | Yes |
| Battery Type | 27A 12V Alkaline Battery |
| Warranty | 1 Year |
Remote Pro RPC419 Aftermarket Garage Door Remote Compatibility
This RPC419 garage door remote replacement is compatible with RemotePro RPC419 systems. If your current remote has RPC419 written on the front, this remote will program and operate exactly the same.
Whilst this remote may look similar to other black sliding cover remotes in the industry, this is not a ‘universal’ garage door remote.
See the full range of Remote Pro Aftermarket Garage Door and Gate Remotes here
RemotePro RPC419 Aftermarket Garage Door Remote Features
With a black casing complemented by a sturdy metal trim, these remotes are built to last. The sliding cover protects the buttons from dust and accidental presses, helping prolong the lifespan of the remote. Its compact design makes it practical and easy to carry without being bulky or cumbersome. This four-button, 4-channel remote allows you to control multiple garage doors or gate systems from one device, offering the same functionality and reliability you would expect from the RPC419 model. You can replace your old or lost remote without paying extra purely for branding.
RPC419 Programming Instructions
1. Depending on your motor’s model you may need to remove a screw to allow the hinged cover to open. Once open locate the RED push button which is located on the main circuit board panel.
2. Press this button for approximately 3-5 seconds until the LED indicator light begins to flash. Once flashing this indicates that your motor has successfully entered learn mode.
3. On the new remote, press and hold any button that you wish to operate the door. The LED on the motor should stop flashing after1-2 seconds once the remote has been programmed.
Erasing Motor Memory
1. Push and hold the red button on the circuit board panel for 10 seconds. After 3 seconds the light will begin to blink and after 10 seconds the light will remain on.
2. After the light remains on, release the red button. Test to ensure your remotes have been erased.
Reviews
There are no reviews yet.